Cladding¶
Cladding replaces a procedural surface with real static mesh pieces from the pack: siding boards on a wall, skirt tiles on a deck, panels on a stairwell shaft. It's what turns a blocked-out shell into a finished-looking building.
Cladding is geometry; painting is colour. You can do either, or both.
Shot with the Residential Houses – Modular Pack. See Compatible Packs.
Clad a surface¶
- Select the Clad tool ().
- Choose Walls, Fence or Platform in the type bar under the toolbar. The catalog narrows to styles of that kind.
- Pick a style in the catalog. Nothing clads until one is armed.
- Click a surface.
| Input | What it clads |
|---|---|
| Click | The wall face under the cursor |
| Shift + click | The whole straight run on that side |
| Shift+Alt + click | The whole room interior, the building's exterior circumference, or a connected open wall |
| Ctrl + click | Removes the cladding. Mixes with Shift and Shift+Alt to strip that whole set |
| Drag | Every wall face the stroke crosses, as one undo step. See Clad by dragging |
Cladding is per face: the inside and the outside of a wall are clad separately, exactly like paint.
Those rows are about wall faces. With the Fence or Platform chip a click restyles the whole fence run or deck at once, so Shift has nothing to widen.
The hover highlight shows exactly what a click would clad, so you can check the extent before committing. Under Ctrl it turns red, and the click strips that same set rather than cladding it.
Full list: Hotkeys.
Clad by dragging¶
To clad several walls at once, press on a wall face, drag across the walls you want and release. They are all clad as one undo step, and the highlight grows with the stroke so you can see what it will take.
- Hold Shift and each face the stroke crosses takes its whole run.
- Hold Ctrl as you press and the stroke strips cladding instead.
A click without a drag works exactly as before. Fences and platforms stay click-only.
Where a style's run ends¶
A style can close its runs with end caps: a pilaster at the end of a band of brick, say, or the closed end of a canopy. A cap is placed only where the run stops, against another style, an unclad face or a free wall end, and never where the face carries on in the same style, along the wall or round a corner. Change one wall's cladding and the caps move to the new ends by themselves. Caps come with the pack. See Wall Cladding → Run ends.
Staircase railings are fences¶
A staircase's railing is built from fence pieces, so you style it with the Fence chip:
- Select the Clad tool, then the Fence chip.
- Choose a fence style in the catalog.
- Click the staircase.
The railing is then built from that style's own meshes: posts, balusters, the top handrail and the bottom rail if the style has one. It follows the steps up through straight runs and L/U turns. A stair with no railing yet gets one on both sides.
Ctrl + click clears the style back to the default railing look and leaves the rail standing. Which sides carry one is a stair setting rather than a style, set with the Edit tool (). See Stairs → Edit widget.
The shaft walls and the walls under a staircase take a cladding style instead of a fence one. See Stairs → Cladding a staircase.
Clad a building, then change one wall¶
- Select the Clad tool, the Walls chip and a cladding style.
- Shift+Alt + click any exterior wall. The whole circumference takes that style in one go.
- Pick a different style in the catalog.
- Click a single wall face. Only that face changes.
Each face holds its own style, so one building can carry several.