Walls¶
Walls are the heart of HausTools. Draw a run and it snaps to the grid, square or at 45°, then connects to the walls it meets. A run is as long as you drag it.
Draw a plot first
Walls only work inside a plot. If the Walls tool won't draw, that's almost always why.
Drawing¶
- Select the Walls tool (), in the toolbar's Building tools group.
- Click to anchor one end of a run, or hold and drag toward the far end instead. Nothing is built on the press either way.
- Move to preview; the ghost wall and a length readout follow the cursor.
- Click again to build that run, or release the drag.
A closed loop is a room
Each run is its own gesture, so a four-sided room is four runs. Runs that meet are joined, and when they close a loop HausTools treats the inside as a room, which is what gives it a floor and ceiling.
Clicking the anchor a second time cancels a run you have started but not finished, and Esc cancels whatever gesture is in progress.
Faster than run by run
Shift + drag draws a whole room in one gesture, Ctrl + drag deletes the walls along the drag, and Shift+Ctrl + drag erases every wall inside a rectangle. They re-route the gesture live, so you can press them part-way through a drag.
To put a door or window in a wall, you don't edit the wall directly. The opening tools cut a void and drop a frame into it. See Doors & Windows.
Drawing at 45°¶
A run snaps to one of eight directions: the four square ones and the four diagonals. Nothing in between, so any two runs mitre cleanly wherever they meet.
Draw a diagonal exactly as you draw a square run, clicked or dragged. A 45° run junctions into square runs on either side, and a wing drawn at 45° gets its floor, ceiling and room detection like any other closed loop.
Hotkeys¶
| Input | Action |
|---|---|
| Esc | Cancel the run in progress |
| Shift + drag | Switch to room mode: drag a rectangle and get four mitred walls at once, instead of drawing a run |
| Ctrl + drag | Delete the wall segments under the drag line |
| Ctrl + click, click | Delete the wall span between the two clicks, easier to aim than a drag on a long run |
| Shift+Ctrl + drag | Drag a rectangle and delete every wall inside it, ghosted red while you drag |
| Ctrl+Z / Ctrl+Y | Undo / redo |
Full list: Hotkeys.
Height and thickness¶
A pack sets the wall height, since its wall pieces are built for it, and normally the thickness too. Without a pack, both come from Project Settings: 280 cm tall and 20 cm thick out of the box. Change the pack or the setting and every wall follows on the next rebuild.
A wall style can also set its own Wall Thickness and Storey Height (see Making a Style):
- Thickness. A wall takes the thickness of the style that clads it. Where its two faces wear different styles the thicker one wins, so an outside wall with an inside lining keeps the outside wall's thickness. Change a style's thickness and the walls already clad with it follow. Take the style off, or replace it with one that sets no thickness, and the wall goes back to the pack's.
- Height. A taller style raises the whole storey it stands on. See Multiple Storeys → Storey heights.
Styles left on Pack Default change nothing.