Skip to content

Multiple Storeys

Buildings go up one storey at a time. You draw into the storey you are on, and you see it with everything below it, so the walls upstairs land on the rooms downstairs.

Adding or removing a floor

  1. Press add floor () in the toolbar's floor stepper, or the same button on a room's Edit widget.
  2. Draw walls on the new storey exactly as you did downstairs.

The new storey arrives empty, with a floor already covering the structure below, and the stepper jumps up to it so you can start drawing straight away.

Every storey is one wall height tall, so the floor above lands on the ceiling below. That height comes from the pack, and there is nothing to set on the storey itself. See Walls → Height and thickness.

Storey heights

A wall style can set the height of the storeys it stands on (see Making a Style). Clad a storey's walls with a taller style and that storey grows, and the storeys above stack on it with their walls, floors, ceilings, stairs and roofs following. That is how a shop gets a double-height ground floor under normal flats.

The settings sit at the right of the wall style's tiles in the catalog, under HEIGHTS (how to reach them):

Setting Default What it does
Pack Default Ticked Keeps the pack's storey height and ceiling. Untick it to set the two below
Storey Height The pack's The height of the storeys this style stands on
Ceiling Height The pack's The ceiling in rooms lined with this style, measured from the floor. A room can override it

Full list: Style settings.

  • Each storey takes the largest Storey Height among the styles on its walls.
  • Each building keeps its own heights. Separate buildings on one plot take their storey heights from their own walls only, so a tall building beside a short one keeps its height, and buildings from different packs each keep their own pack's height.
  • Storey by storey. A building can have a tall ground floor with shorter floors above, a short one with taller floors above, or every floor different. Changing the cladding on one storey moves only the storeys above it, in that building.

Packs whose styles leave Storey Height on Pack Default build exactly as before, every storey one wall height.

Floors belong to a structure, not to the plot. Two detached buildings on one plot each keep their own floor count, and the stepper follows whichever one you have selected. On a plot with a single building you can just press add.

Remove floor () takes the top storey off again, one at a time. The ground floor is not removable: a building always has one.

Removing a floor takes its contents with it

Remove floor deletes everything placed on that structure's top storey: walls, openings, roofs, decks, fences, stairs, dropped floors and paint. It asks first, defaulting to No, and unlike removing a plot it is undoable. Adding a floor back gives you a fresh empty storey, not the old contents.

Moving between storeys

The toolbar's floor stepper is how you change levels:

down · Floor 1/2 · up · add · remove the top floor

You see the active storey and everything below it. Step down to the ground floor of a two-storey house and the upper storey is hidden while you work, then comes back when you step up. Everything you draw, walls, openings, roofs, fences and stairs, belongs to the storey that is active when you draw it.

The Dollhouse cutaway () opens the active storey's walls so you can see into the room you are editing. See Dollhouse & Isolate.

Upper floors

  • The floor of a new storey is one seamless piece covering the structure below, so painting it takes a single click.
  • Where an upper storey has its own rooms, each room's floor paints separately; the area outside those rooms stays one merged piece.
  • Where a roof reaches past the walls, over a porch or open air, the floor above grows over that span too, so an attic gable wall stands on a real floor.
  • A staircase cuts its own stairwell through the floor above it, edged with a rim board.